TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
LEGEND TO FIGURE 8-15
(1) Note that bottom connector of
moved for this procedure and must
tube assembly (38) is free since it was
be match marked if it ever is re-
previously removed from the vent dryer.
moved.
(2) Remove rear connector of tube
(1) Remove top connector of tube
assembly (43) from tee (44) at top of
assembly (14) from tee (44) at top of
reservoir.
Remove and discard copper
reservoir.
Remove and discard copper
seal.
seal.
(3) Withdraw tube assemblies with
(2) Remove bottom connector of
check valve (39) , from module.
tube assembly (16) from fitting welded
to baseplate of module. Remove and dis-
j. Remove tube assemblies (14 and
card copper seal.
16) as follows:
(3) Withdraw tube assemblies, with
NOTE
check valve (15) from module.
Do not remove tee connector (44)
Remove tube assembly (10) as fol-
k.
at this time. It need not be re-
lows:
8-30