TM 5-1730-245-14
CHAPTER 6
GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Page
GENERAL SUPPORT MAINTENANCE PROCEDURES ................................ ................. 6-1
Introduction ................................ ................................ ................................ ...... 6-1
Hydraulic Fluid Pump ................................ ................................ ....................... 6-1
Thermal Control Module ................................ ................................ ................... 6-3
Engine Block Assembly ................................ ................................ .................... 6-4
Governor Stop/Run Lever ................................ ................................ ................ 6-7
Fuel Injector Pump
................................ ................................ ................... 6-8
SECTION I. GENERAL SUPPORT MAINTENANCE PROCEDURES
6.1 INTRODUCTION This section details those major maintenance procedures which would be carried out at a
general support level.
6.2 HYDRAULIC FLUID PUMP - REPLACE.
THIS TASK CONSISTS OF: a Removal
b Installation
INITIAL SETUP
Tools:
Equipment Condition:
Toolkit, General Mechanics (item 5, Section III, Appendix B).
Shop Equipment Automotive Maintenance and Repair:
Battery disconnected. Refer to paragraph 4 9.
1
Organizational Maintenance, Common No 1, less power
General Safety Requirements:
Material/Parts Required
WARNING
Hydraulic oils are toxic and flammable.
Do not use near heat or open flame
Area should be well ventilated. DO NOT SMOKE.
1) Remove the inlet hose (3) and adapter fitting (4) at pump (5). Remove the two discharge hoses at the
2) Remove screws (6), flatwashers (8) and lockwashers (7) holding pump (5) to engine.
3) Slide the pump (5) rearward.
6-1