TM 11-6130-243-35-1
A/U meter reading at T1, T2, and
(2) Power cable (as fabricated).
T3 is greater than 10 megohms.
(3) Mating connector (FSN 5935-236-
4640).
(4) Disconnect the ZM-21A/U from the
PP-4606A/G.
b. Test Connections and Conditions. Connect
the equipment as shown in figure 3-2. (This
36. Output Power Test at 440-Volt Input
test is written for operation of the power sup-
a. Material.
ply at 440 volts ac.) Do not connect the load
to the power supply until instructed to do so in
(1) Resistance element, 0.41-ohm, 3,400 -
the procedure given in c below.
watt; 3 each.
c. Procedure.
