TM 5-1730-245-14
4) Loosen screw (1) in the pump coupling (2) and remove coupling (2).
5) Remove the two discharge hoses (10) from the pump.
b. Installation. Refer to figure 6-1.
1) Install the coupling (2) on the pump (5) so the front face of the coupling is 1.8/2.0 inches (46/50 mm)
from the front face of the pump Tighten setscrew (1) in the coupling (2).
2) Install the two discharge hoses (10) to the pump (5).
3) Install the pump (5) on the engine rotating it slightly to align the splines. Make sure the side of the
pump with the single inlet port is on the same side as the inlet hose (3) and the double port side
faces the discharge hoses (10). Install lockwashers (8), flatwashers (7), screws (6) and tighten.
4) Install the two discharge hoses at hydraulic control manifold (7, fig. .5-5).
5) Install the adapter fitting (4) and inlet hose (3) to pump
6) Fill the hydraulic fluid tank. Refer to paragraph 4 3
Figure 6-1. Pump.
6-2
