TM 5-1730-245-14
6.5 GOVERNOR STOP/RUN LEVER - ADJUST.
THIS TASK CONSISTS OF: a. Adjustment
INITIAL SETUP
Tools:
Equipment Condition:
Toolkit, General Mechanics (item 5, Section HII, Appendix B). Side panels (8, fig. 1-2) removed.
Shop Equipment, Automotive Maintenance and Repair:
Battery disconnected. Refer to paragraph 4.19.
Organizational Maintenance, Common No 1, less
power (item 6, Section III, Appendix B)
Governor setting gauge, item 2, Appendix B.
a. Adjustment. Refer to figure 6-4.
NOTE
The governor must be correctly adjusted before the fuel pumps can be installed.
1) Turn the governor stop/run control lever (1) counterclockwise to the stop position
2) Adjust the screw (5) until It just touches the radiused part of the engine control lever (1) and lock
in this position with the nut (4)
3) Insert governor setting gauge (6) between lever (1) and set screw (5) to obtain a dimension of
0.925 in/23 5 mm.
4) Adjust setscrew (2) to just touch the lever In this position
5) Tighten the setscrew locknut (3) and remove the governor setting gauge (6).
Figure 6-4. Governor Stop/Run Lever.
6-7
