TM 5-1730-245-14
6.3 THERMAL CONTROL MODULE - REPLACE.
THIS TASK CONSISTS OF:
a. Removal
b. Installation
INITIAL SETUP
Tools:
Equipment Condition:
Toolkit, General Mechanics (item 5, Section III, Appendix B).
Side panels (8, fig. 1-2) removed.
Shop Equipment, Automotive Maintenance and Repair:
Battery disconnected Refer to paragraph 4.19.
Organizational Maintenance, Common No 1, less
Hydraulic fluid tank drained. Refer to para. 4.3.
power (item 6, Section III, Appendix B).
Material/Parts Required:
Silicone sealant, item 17, Appendix E.
a. Removal, Refer to figure 6-2.
1) Disconnect tube (1) from adapter (2)
2) Remove screws (8), lockwashers (7) and connection block (3) from the hydraulic control manifold (6)
3) Remove thermal control module (4)
b. Installation. Refer to figure 6-2.
NOTE
Silicone sealant is used to form a new gasket Ensure surfaces are free of
contamination prior to application
1) Insert the thermal control module (4) in the cavity of the hydraulic control manifold (6).
2) Apply silicone sealant to surface of connection block (3)
3) Install the connection block (3) with screws (8) and lockwashers (7). Torque the bolts to 5 0 ft. lb./ 7
Nm.
4) Install tube (1) to adapter (2)
Figure 6-2. Thermal Control Module.
6-3
