TM 55-1730-229-12
AC 320A0-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
(8) Set aircraft DC load control
s w i t c h e s to OFF.
During the conduct of this procedure
(9)
Set
DC
POWER
switch
(2)
to
the operator of the AGPU must be in
OFF.
intercom communication with the air-
craft pilot or mechanic at all times.
a. Load Connection.
(10) Disconnect DC cable from air-
start procedure in
(1)
Perform
craft.
paragraph 2-3 if engine is not running
12-2-13
P n e u m a t i c Load Connection - C o n t r o l P a n e l F u n c t i o n s
( 2 ) E n s u r e that PNEUMATIC POWER
switch (1, figure 2-13) is set to OFF.
Pneumatic hose and adapter fitting
b e c o m e extremely hot when pneumatic
power is applied. Never touch hose
or adapter fitting until pneumatic
power is removed and hose and
a d a p t e r f i t t i n g h a v e c o o l e d . Wear
H a n d l e hose with care so spiral
proper gloves and eye protection
w r a p and netting are not damaged.
(goggles or face shield) when op-
Keep hose off ground if wet or
e r a t i n g pneumatic system.
muddy (use suitable supports).
