TM
55-1730-229-12
AG
320A0-OMM-000
TO
35C2-3-473-1
TM
1730-12/1
(g) STARTER CURRENT meter (5) reads zero
when % RPM meter exceeds 60%.
Check that OUTPUT PRESSURE gauge
(h) STARTER ON light (4) goes out when %
on hydraulic control panel indi-
RPM meter exceeds 60%.
cates a minimum of 500 psig (un-
less hydraulic pump spacer is in-
stalled). If less than 500 psig,
(i) EGT meter (8) reads in green band within
immediately set ENGINE CONTROL
60 seconds of initiating start sequence.
switch to STOP to prevent damage
to hydraulic pump.
(j) % RPM meter (9) reads in green band.
(k) BATTERY CHG/DISCH meter (10) indi-
AC MODE. OPERATION.
cates CHARGE.
(1) CHG/BAT fault indicator light (11) goes
out.
During the conduct of this procedure
the operator of the AGPU must be in
intercom communication with the air-
craft pilot or mechanic at all times.
a. Load Connection.
(1) Perform start procedure in
paragraph 2-3 if engine is not running.
12-2-9
