TM 55-1730-229-12
SECTION II.
LUBRICATION INSTRUCTIONS
activity. If extended, adequate preservation precautions
sure continued operation, lubrication of certain moving
must be taken.
parts on the AGPU is required. This Lubrication Or-
der reproduced in this section shows the areas of the
b. Oil changes shall be determined by hard-time
AGPU which require lubrication, the proper lubricant to
intervals.
be used, and the frequency of lubrication.
cation shall be determined by hard-time intervals.
a. Hard time intervals and the related man-hour
d. Clean fittings before lubricating. Lubricate points
times are based on normal operation. The man-hour
indicated by dotted arrow shaft on both sides of equip-
time specified is that time you need to do all the ser-
ment. Clean parts with degreasing solvent, MIL-PRF-
vices prescribed for a particular interval. Change the
680. Dry before lubricating. Drain gearcases when
interval if your lubricants are contaminated or if you
HOT. Fill and check level. The lowest level of mainte-
are operating the equipment under adverse operating
nance authorized to lubricate a point is indicated by one
conditions, including longer-than-usual operating hours.
of the following (C) Operator/Crew or (O) Organizational
The interval may be extended during periods of low
Maintenance.
TOTAL MAN-HOURS
INTERVAL
MAN-HOURS
D
0.1
1.5
S
A
6.0
250
1.5
