TM 55-1730-229-12
AG 320A0-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
(4) Remove two ejector tube assem-
(2) Insert curved end of holddown
blies (20, sheet 2) by removing eight
rod (4) into slot in floor of battery
bolts (18) and four brackets (19).
compartment.
Position threaded end of
holddown rod (4) into slot in battery
(5) Loosen two hose clamps (6) and
cover (8). Secure holddown rod in place
disconnect two bleed air hoses (7) from
with washer (3) and wing nut (2).
fittings on bottom of air cleaner (14).
(3) Connect battery connector.
(6) Remove four screws (8), lock-
washers (9), and flat washers (10) from
bottom of outer duct (17).
spect as follows:
a. Open engine access door.
(7) Remove air cleaner (14) by re-
moving twelve screws (11), lockwashers
b. Inspect exhaust ejector assembly,
(12), and flat washers (13).
figure 1-8, for security of installa-
tion, damaged insulation, and missing
(8) Inspect gaskets (15, 16) for
Reuse
or loose insulation retaining washers.
cuts, tears or other damage.
gasket if not damaged.
Small cracks, dents, and cuts in in-
sulation are acceptable.
Open exhaust
flapper and use flashlight to inspect
(9) Inspect six air cleaner noz-
interior of assembly for damage, cracks,
zles (22) for cracks or deformation.
and erroded housing.
Replace air cleaner if damaged.
AIR CLEARER ASSEMBLY.
(10) Inspect six nozzles (22) for
clogged openings. If clogged, use small
wire to remove obstruction (do not en-
Inspect.
(See figure 4-9.)
a.
large openings).
(1) Remove intake cover (9, figure
4-5) and shroud (10) by removing eight
Inspect air cleaner
screws (7) and washers (8).
c. Repair.
for missing or damaged tubes (21, figure
(2) Inspect air cleaner assembly
Replace air cleaner if tubes are
(14, figure 4-9) for missing or damaged
Replace broken or
missing or damaged.
Remove debris and vacuum
cracked ejector tube assemblies (20,
tubes (21).
out all tubes and face of cleaner. Re-
place cleaner assembly if tubes are
missing or damaged.
(See figure 4-9.)
Install.
d.
Remove.
(See figure 4-9.)
b.
(1) Ensure gaskets (15, 16) are in
position on outer duct (17).
(1) Remove intake cover and shroud
by performing step a. (1).
(2) Install air cleaner (14) and
(2) Open engine access door.
secure with twelve screws (11), lock-
washer (12), and flat washers (13).
(3) Remove ejector tube cover (3)
(3) Install four screws (8), lock-
by removing four screws (1), washers
washers (9), and flat washers (10) at
(2), and two lockwashers (4), and two
bottom of outer duct (17).
nuts (5).
