TM
55-1730-229-12
AG
320A0-OMM-000
TO
35C2-3-473-1
TM
1730-12/1
WASHER, STAR
4.
1.
NUT
GROUND STUD
2.
WASHER, LOCK
5.
WASHER, STAR
3.
Ground Stud Installation
(See figure 4-11.)
(4) Install gearcase drain tube
Install.
b.
(14). Route tube through floor grommet.
(1) Install exhaust ejector drain
(5) Install hydraulic pump drain
tube (18).
tube (4) by threading tube into ejector.
Install cover (3) with four attaching
(6) Close engine access door.
screws (1) and washers (2).
INSULATION.
Open GTE access
(2) Install two engine drain tubes
door and inspect interior insulation for
damage, and loose or missing retaining
(5, 7). Route tubes through floor grom-
washers.
Minor damage to insulation
mets.
such as dents, minor cuts or abrasion is
allowed.
Notify maintenance supervisor
(3) Install fuel control unit
if portions of insulation are missing,
Route tube
(FCU) drain tube (10).
or retaining washers are missing.
through floor grommet.
Section IX.
MAINTENANCE OF DC ELECTRICAL AND CONTROL SYSTEM
4-23. GENERAL. The
major components
are listed in table 4-10, with location
and figure references.
of the dc electrical and control system
