TM 55-1730-229-12
AG 320A0-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
(6) Install ejector tube cover (3)
with four screws (1), washers (2), and
two lockwashers (4), and two nuts (5).
(7) Install intake cover (9, fig-
ure 4-5) and shroud (10) with eight
screws (7) and washers (8).
GROUND STUD.
Remove.
(See
Remove nut (1) washer (2), star washer
(3), and remove ground stud (5) with
star washer (4).
b. Install. (See figure 4-10.)
Ensure that area around hole in chassis
is clean and free from corrosion. In-
stall star washer (4) on ground stud (5)
and install in hole in chassis. Install
washer (2), star washer (3), and nut
(1).
DRAIN TUBES.
(See figure 4-11.)
a. Remove.
(1) Remove exhaust ejector drain
tube (4) by unthreading tube, after re-
moval of cover (3) and four attaching
screws (1) and washers (2).
(2) Open engine access door (12,
Figure 4-9. Air Cleaner and Air Intake
(3) Remove two engine drain tubes
Duct Assemblies (sheet 2 of 2)
(5 and 7, figure 4-11).
(4) Remove fuel control unit (FCU)
(4) Connect two bleed air hoses
drain tube (10).
(7) to fittings on bottom of air cleaner
(14), and secure by tightening two hose
(5) Remove gearcase drain tube
clamps (6).
(14).
(5) Install two ejector tube as-
(6) Remove hydraulic pump drain
semblies (20) with four brackets (19)
tube (18).
and eight bolts (18).
