TM 55-1730-229-12
AC 32OAO-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
(4) Check resistor for security of
(f) Use ID tags and install
installation.
wires to TB.
Tighten mounting screws
(8) as required.
(5) Check that wires (5) are se-
(2) Install TB1 Anode, TB1 Cath-
curely connected to resistor terminals.
(See
ode, TB2 Anode, and TB2 Cathode.
Tighten terminal nuts (1) as required.
Remove.
b.
(a) If installing TB1 cathode
(9), install jumpers at positions indi-
(1) Check that battery is discon-
cated (8, figure 4-21).
nected.
(b) If installing TB2 anode (11,
(2) Remove roof (see paragraph
figure 4-20), install jumpers (4) at
positions indicated (4, figure 4-22).
(3) Disconnect wires from resistor
(c) Install terminal board (8,
by removing two nuts (1), lockwashers
9, 10, or 11, figure 4-20) with two
(2), screws (3), and washers (4).
screws (7) and nuts (6).
(4) Remove two nuts (6), lock-
(d) Install electrical compo-
washers (7), screws (8), washers (9),
Use ID tags and figure
nents on TB.
brackets (10), and resistor (11).
4-21 (TB1) or figure 4-22 (TB2) for
reference.
c. Install. (See figure 4-25.)
install
ID tags and
(e) Use
(1) Insert brackets (10) into ends
wires to TB.
of resistor (11).
(2) Attach brackets to tray com-
4-34. GENERATOR DC LOAD RESISTOR (R4).
partment wall using two washers (9),
screws (8), lockwashers (7), and nuts
(6).
(3) Install wires (5) disconnected
Remove all rings, watches and other
in step b. to resistor terminals using
jewelry when performing maintenance
screws (3), washers (4), lockwashers
on this equipment.
(2), and nuts (1).
NOTE
(4) Install roof (paragraph 4-16).
See table 4-2, Malfunction 43
(step 11) for test.
(2CB1-2cB2).
Inspect. (See figure 4-25).
a.
(1) Disconnect battery.
Remove all rings, watches and other
jewelry when performing maintenance
(2) Open electrical trays access
on this equipment.
door (9, figure 1-1).
(3) Inspect resistor (11, figure
a. Inspect.
(See figure 4-26.)
4-25) on step above upper electrical
tray for obvious damage. Replace resis-
(1) Disconnect battery.
tor if cracked.
Change 1
