TM 55-1730-229-12
AG 320A0-OMM-000
TO 35C2-3-473-l
TM 1730-12/l
stop
ramp into the cargo compartment.
on the
(d) Lay the shoring
when the AGPU is centered at station
helicopter's ramps and cargo compartment
320, figure 4-2, sheet 1 of 2.
floor for the AGPU to roll on during
loading.
(c) When AGPU is in position at
station 320, set parking brake.
(3) Prepare AGPU for self-propul-
sion mode in accordance with applicable
(d) Set DRIVE switch, DC POWER
steps in paragraph 2-10.b.
and MASTER SWITCH on AGPU control panel
to OFF positions. Disengage clutch, and
(4) Load AGPU into Helicopter.
latch tow bar to stored position-
(a) Position one man to the rear
NOTE
of AGPU to observe lateral clearances.
Position another man in front of the
The AGPU is resting on and sup-
AGPU to observe clearances and give hand
ported by the parking shoring dur-
signals to the AGPU operator.
ing transport. Remove the rolling
shoring and secure it inside the
(b) Using propulsion controls on
helicopter cargo compartment.
AGPU back the AGPU up the helicopter
STA
STA
STA
STA
320
420
220
120
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
O
10000 Lb TIEDOWN FITTING
5000 Lb TIEDOWN FITTING
LOCATION OF R.P.
APPROX
ITEM
DESCRIPTION OF ITEM
FACING
WT(LB)
STA
R.P.
AVIATION
GROUND
POWER
AFT
CENTERED
320
4000
UNIT(AGPU)
12-4-2
Tiedown of AGPU for IAT (sheet 1 of 2)
