TM 55-1730-229-34
A 320A0-MME-000
TO 35 C2-3-473-2
TM 1730-34/1
NOTE
(3) Loosen clamp nut (1, figure
Match mark retainer halves (13)
puller 293171-1 (3) and install puller
with swivel pad (4) on end of shaft
and plenum (21) to housing (22)
centered on turbine wheel (5). Install
for aid during assembly.
clamp (2) on engine exhaust flange (6)
and tighten clamp nut (1). Turn nut (8)
(2) Remove bolts (11) , washers
on puller shaft (7) until turbine plenum
breaks loose. Remove puller.
(12) and retainer halves (13).
(4) Carefully slide plenum off to
clear turbine wheel (15, figure 9-10).
Remove plenum from engine.
Turbine plenum must be supported
NOTE
during removal procedure if engine
is not mounted with exhaust end
up. Failure to support turbine
Match mark turbine housing scroll
plenum during removal could result
(20, figure 9-10) to turbine plenum
in damage to turbine wheel.
assembly (21) for aid during assembly.
34-9-11
TURBINE WHEEL
CLAMP, NUT
5.
1.
6.
EXHAUST FLANGE
2.
CLAMP
PULLER SHAFT
PULLER, TURBINE PLENUM
7.
3.
8.
NUT
4.
PAD, SWIVEL
Figure 9-11.
Installation of Turbine Plenum Puller
9-25
