TM 55-1730-229-12
AG 320A0-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
Organizational Troubleshooting (continued)
Table 4-2.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14.
(continued)
Check continuity
If no continuity,
replace wire no.
From
To
Q5A20
J5-13L
1DS6(-)
Q5B20
P5-13R
S5
Q7B20N
GND TB
S5
See figure 4-53 (10) for pressure sensor S5 location, and figure
4-20 (2) for GND TR location.
If no continuity, replace indicated wire.
a.
If all continuity checks good, replace fuel pressure sensor
b.
c. Reconnect connectors, and perform operational check.
ENGINE DOES NOT MOTOR WITH ENGINE CONTROL SWITCH HELD IN START POSITION (MASTER
15.
SWITCH ON AND ALL OTHER SWITCHES OFF).
Step 1.
Check GTE 10 AMP circuit breaker.
a. If circuit breaker is closed (pushed in), go to Step 2.
If circuit breaker is opened (popped out), reset (push in).
b.
If circuit breaker continues to open, disconnect battery and
check all GTE circuit breaker loads (see FO-1 and F0-3 sheet
1) for shorts.
Check GTE indicator lights.
Step 2.
a. If CONTROL SHORT, HIGH EGT, HIGH OIL TEMP, or OVER SPEED
indicator light is illuminated, see malfunctions 30 through
33.
b.
If CONTROL SHORT, HIGH EGT, HI OIL TEMP, and OVER SPEED
indicators are all extinguished, continue with step 3.
Test starter circuits as follows:
Step 3.
a. Disconnect battery and remove roof.
